How to make EtherChannel on Cisco Switches

Hi again
To involve two NIC in switch trunking  just need a simple configuration on both switches.

in configuration mode just select each interface and apply the same channel mode to them.

therefore we should run the following commands :

FirstSwitch#conf t

Enter configuration commands, one per line. End with CNTL/Z.
FirstSwitch(config)#interface fast 0/23

FirstSwitch(config-if)#channel-group 1 mode on

Creating a port-channel interface Port-channel 1

FirstSwitch(config-if)#interface fast 0/24

FirstSwitch(config-if)#channel-group 1 mode on

there is still problem. if one interfaces will down the hole trunking system has been stop. is there any idea to have multiple trunk interface with redundancy ?!

thats it

2 Responses to “How to make EtherChannel on Cisco Switches”

  • Ebonie Moorehead:

    I really liked reading your post!. Quallity content. With such a valuable blog i believe you deserve to be ranking even higher in the search engines :) . Check out the link in my name. That links to a tool that really helped me rank high in google. This way even more people can enjoy your posts and nothing beats a big audiance ;)

Leave a Reply

*

     Copyrighted Mehdi Behamin , All Rights Reserved
    
Blog has been visited 207160 times